When you’re buying a brick house, read the brick lines of the inspection report first. Look at whether the brick is the wall itself or siding over a wood frame. Then read what the report says about any cracks and about the mortar. Water getting into the wall is the other thing to watch. A full home inspection looks at the wall covering and at the structure. Where a brick line calls for more, the report can point you to a structural engineer or a mason.

Skim past those lines and you can close on cracks, worn mortar or water getting into the wall with the inspection contingency already spent. By then there’s no repair request on the table and no engineer’s visit arranged. Read them while you still have room to act. This is general information for buyers, not engineering, legal or financial advice.

Is the Brick the Wall or Just the Siding?

It can be either. An ASHI Reporter article on brick veneer and solid masonry says masonry walls “may be a load-bearing part of the structure, or they may just be siding (masonry veneer).” It also says “The absence of header courses or the presence of weep holes suggests veneer.”

“Load-bearing masonry walls hold up the floors and the roof,” ASHI’s journal says. With veneer, it says, “the building would stand if all the masonry was removed. The structural skeleton is usually a wood frame inside the masonry siding.” As a general rule, which kind you’re buying changes which report lines matter. On a load-bearing wall the brick is the structure. On veneer, what sits behind it is.

A Philadelphia rowhome adds shared walls. Dense brick rowhomes can hide problems the listing photos never show, and shared brick walls can settle differently than the adjoining home, producing step cracks that range from cosmetic to structural. Where a step crack sits in that range is a question for the report. Our guide to a home inspection in Philadelphia covers the rest of what rowhome buyers ask.

What Does the Inspection Check on a Brick Wall?

The wall covering and the structure. InterNACHI’s Standards of Practice say the inspector inspects “the exterior wall-covering materials” and “flashing and trim,” and describes “the type of exterior wall-covering materials.” On a brick house, that wall covering is the brick. A visual inspection can report only what is visible and accessible on the day.

The Standards’ structure section lists “observed indications of active water penetration” and “observed indications of possible foundation movement, such as sheetrock cracks, brick cracks” among what the inspector reports as in need of correction.

During a home inspection, one of our licensed inspectors performs a visual examination of the structure and all major systems, then documents every finding with photographs. We inspect everything from a century-old rowhome in Philadelphia to new construction in Delaware County.

There’s a limit. Under the Standards the inspector is not required to “inspect items that are not visible or readily accessible from the ground, including window and door flashing.” As a general rule, paint, coatings or plantings on a brick wall can keep parts of it out of view.

Which Brick Cracks Matter When You Buy?

Read what the report says about each one. ASHI’s journal says “Two of the most common problems are cracking and mortar deterioration.” It also says “Cracked masonry or mortar units may be cosmetic, may be water entry points or may indicate severe structural problems.” A crack line is a question to answer, not a verdict on its own.

The same article says “Several small cracks across the wall surface may indicate considerable movement.” It advises inspectors to “Watch for deteriorated mortar and brick movement in the wall, especially at arches.”

Under the Standards the inspector is not required to “report on the adequacy of any structural system or component,” or to “provide any engineering or architectural service.” So when a report sends a crack to a structural engineer, that’s the next step, and it takes time inside the contingency.

A report can carry the line “Recommend further evaluation by a licensed structural engineer.” It means the inspector saw a pattern that needs a load and movement analysis to interpret correctly. We cover that line in our post on foundation issues.

What Does Worn Mortar Mean for a Buyer?

For a buyer, it means a question for a qualified mason and a line to read closely in the report. ASHI’s journal says “Mortar deterioration is common on masonry, especially areas that are exposed to considerable wetting.” It also says “Deteriorating mortar may result in water damage to the building interior and to the masonry.”

ASHI’s journal also says “Repointing is relatively expensive, and it is difficult to match the color and texture of old mortar with new.” And it says “We don’t want mortar that is stronger than the masonry.”

The same article says “Remember that virtually all old houses have areas where mortar could be improved.” So on an older brick house, the questions for a mortar note are where the report puts it and what it recommends. A buyer can ask the seller whether and when the brick was repointed and by whom. Repair method and price are questions for a qualified mason.

How Does Water Get Into a Brick Wall?

ASHI’s journal points to cracks and to the bond between the mortar and the masonry. Its list of conditions inspectors find on masonry walls runs through efflorescence, spalling, cracking, mortar deterioration, “missing weep holes or flashings,” mechanical damage and bowing walls. Those are the words to look for in the report.

ASHI’s journal says “The cracks allow water into the wall, which may damage the interior skeleton of the building.” It adds that “Moisture entering the cracks also can result in freeze or thaw damage.” On the mortar, it says “A poor bond between the mortar and masonry will allow water into the wall, causing efflorescence and possibly freeze or thaw deterioration.”

That’s why the Standards’ line on “observed indications of active water penetration” is one to read on a brick house, inside as well as out.

Questions to Answer Before Buying a Brick House

The Standards call a home inspection “a non-invasive, visual examination of the accessible areas of a residential property,” and they say “An inspection will not identify concealed or latent defects.” The inspector isn’t required to determine the condition of anything that isn’t readily accessible, or the cause or reason of any condition. So the report tells you what was seen on the day and points to a next step.

Put your questions in writing. A written inspection report gives you something specific to bring to the seller or your real estate agent.

  • Does the report name the type of wall covering?
  • Does it flag brick cracks or other signs of possible foundation movement, and does it recommend a structural engineer?
  • Does it note mortar deterioration, and where on the house?
  • Does it note efflorescence, spalling, missing weep holes or flashing, or signs of water inside?
  • Has the seller had the brick repointed or repaired, and by whom?
  • Is there time left in the inspection contingency for an engineer’s or mason’s visit?

Questions about the agreement of sale and the contingency belong with your real estate agent.

Frequently Asked Questions About Brick Houses

Does a brick house get a different home inspection?

No. It’s the same full home inspection. InterNACHI’s Standards of Practice have the inspector inspect and describe the exterior wall-covering materials on any house, and on a brick house that’s the brick.

How can I tell if a brick house is veneer?

ASHI’s journal says the absence of header courses or the presence of weep holes suggests veneer. The Standards have the inspector describe the type of exterior wall-covering materials. How the wall was built is a question the report and, where one is recommended, a structural engineer can help you answer.

Are small cracks in brick a problem?

ASHI’s journal says cracked masonry or mortar units may be cosmetic, may be water entry points or may indicate severe structural problems. It also says several small cracks across the wall surface may indicate considerable movement. Read what the report says about yours, and the next step it recommends.

Will the inspector check the flashing over the windows?

The Standards have the inspector inspect flashing and trim. They also say the inspector isn’t required to inspect items that aren’t visible or readily accessible from the ground, including window and door flashing. Ask the seller about past repairs; a qualified mason can look closer.

Should brick findings stop me from buying?

That depends on what the report says it saw and the next step it recommends. Your real estate agent handles the contract side. Our reports are delivered within 24 hours.

Read the Brick Lines Before You Sign

Inspection Professionals’ written report documents every finding with photographs and is delivered within 24 hours, so you can see the evidence for each finding rather than a summary.

Knowing whether the brick is the wall or siding over a frame tells you which report lines matter. What the report says about the cracks, the mortar and any water, and what it leaves to an engineer or a mason, helps you decide whether to accept an item, ask for a repair or bring in a specialist before closing.

A full home inspection is the written report to have in hand while you decide.

If you’re buying a brick house in Bucks County, Montgomery County, Philadelphia or Delaware County, contact Inspection Professionals about a full home inspection.